- Start with the pedal powered on and nothing plugged into the CTRL port.
- Hold the right footswitch while plugging in the remote switch. The right LED will blink yellow 3 times to indicate it is in CTRL configuration mode. You can release the right footswitch and begin configuration immediately.
- Press one of the buttons on the remote switch to select a mode.
- Hold the right footswitch for 2 seconds to save the configuration. The right LED will blink green to indicate that the configuration has been saved.
1, 2, 3, and 4-button switches are supported. The modes and functions accessible will depend on the number of buttons. A single-button switch can load or save your favorite sound. A two-button switch can access two presets or be used as a remote for the Tensor’s foot switches.
To save a preset, hold the corresponding button for two seconds. The right LED will blink green to indicate that the preset has been stored. Presets are also accessible via MIDI program change messages.
Tensor Remote Switch Modes
| Mode | Switch | Function | LED Indication |
|---|---|---|---|
| 1 | A | Preset 1 (hold to save) | Blinks green when saved |
| B | Preset 2 (hold to save) | Blinks green when saved | |
| C | Preset 3 (hold to save) | Blinks green when saved | |
| D | Preset 4 (hold to save) | Blinks green when saved | |
| 2 | A | Left footswitch | |
| B | Right footswitch | ||
| C | Preset 1 (hold to save) | Blinks green when saved | |
| D | Preset 2 (hold to save) | Blinks green when saved | |
| 3 Loop Sampler | A | Record / Overdub | |
| B | Play / Stop | ||
| C | Play Once | ||
| D | Toggle TIME & PITCH (tap) Toggle SPEED (double tap) | ||
| 4 | A | Toggle SPEED knob | Blink green (on) / red (off) |
| B | Toggle TIME knob | Blink green (on) / red (off) | |
| C | Toggle PITCH knob | Blink green (on) / red (off) | |
| D | Toggle RAND knob | Blink green (on) / red (off) |